Magnasonic MM172K Specifications download pdf (Page 4)

TO DISPLAY THE DATE

1. Press “Y-M’-D” to display the year, press again to display the date.

2. After five seconds, the time will be displayed.

SLEEP TIMER

1. While the radio is on, press the “SNOOZE” button.

2. The time, in minutes, will flash on the screen for how long you want the radio to play. Press

“SNOOZE” again to toggle desired duration (90, 60, 30, 15).

3. Press “MODE” to set sleep timer.

CARE AND MAINTENANCE

Precautions

1. Always turn off the unit after use.

2. Keep the unit away from magnetic objects, water or heat sources.

3. Use a clean dry cloth to clean the cabinet. Never use chemical cleaners that could damage

the finish of the unit.

4. Disconnect the unit from any power sources before cleaning.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and the receiver.

 Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

 Contact 1-800-663-5954 for any technical support or servicing.

SPECIFICATIONS

Frequency Range: AM 530 - 1710 KHz

FM 88 - 108 MHz

Power Supply: AC 120V ~ 60Hz

Battery Backup DC 9V

(Battery not included)

Specifications are subject to change without notice.

WARNINGS

1. No naked flame sources, such as lighted candles, should be placed on the unit.

2. Do not place the product in closed bookcases or racks without proper ventilation.

3. The power cord is used as the disconnect device, this disconnect device shall remain

readily operable.

- 5 -

4. The ventilation should not be impeded by covering the ventilation openings with items, such

as newspapers, table-cloths, curtains, etc.

5. It shall not be exposed to dripping or splashing and that no objects filled with liquids, such

as vases, shall be placed on the unit.

6. Do not connect FM antenna to outside antenna.

7. The unit should not be exposed to direct sunlight, very high or low temperature, moisture,

vibrations or placed in dusty environment.

8. Do not use abrasive, benzene, thinner or other solvents to clean the surface of the unit. To

clean, wipe it will mild non-abrasive detergent solution and clean soft cloth.

9. Never attempt to insert wires, pins or other such objects into the vents or opening of the

unit.

10. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

CAUTION

Danger o

f explosion if battery is incorrectly replaced

Replace only with the same or equivalent type

Troubleshooting

If you experience a problem with this unit, check the chart below before calling for service.

SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION

GENERAL

Power does not come on. AC line cord not plugged in. Insert plug firmly into AC outlet.

RADIO

Power is not on. Press the Power On/Off button No sound.

VOLUME control at minimum

position

Turn the VOLUME control up.

AM-Interference from traffic. Turn the radio for better AM

reception.

Noise or sound distorted on

AM or FM.

FM-Antenna wire not extended Extend antenna wire.

CLOCK

There has been a power failure

and the clock back-up battery

was too weak to keep the clock

settings.

Replace the clock back-up

battery with a new one.

Incorrect time.

Clock not set. Set the clock.

Alarm is not set to turn on. Slide the ON/OFF/AUTO

FUNCTION SWITCH to the

“AUTO” position to turn the

alarm on.

Clock is not set. Set the clock.

Alarm does not turn on.

Alarm time not set. Set alarm time.

- 6 -

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Magnasonic MM172K Specifications Page 4

Comments to this Manuals